Firmware Update

All new firmware will be accompanied by a new GUI application so that the functions will match. So to update your firmware, you will need to update your GUI application as well. To do this, you will need to completely uninstall the old DSM application by going to Add/Remove Programs in the Control Panel. The DSM Application will be called "DSM".

To install the GUI application again, use the setup files that we have provided.

To update the firmware, please follow the instructions below.

» To update the firmware, power up the DSM board with a jumper on JP3 and click on PHY --> Firmware Update to bring up the Update Firmware dialog box.

» The dialog box will show you the current version of the firmware on the device and the new firmware that you will flash on to the ROM. Please make sure that the new and old firmware are not the same and that the new firmware is the correct one.

» Simply click on Update Firmware to begin the process. It will take approximately 30 to 60 seconds to complete flashing.

» When the firmware finishes, you will get a message in the text box.

» To register the changes to the application, close the application and power down the DSM board. Power up the board and wait for the demo waveform to show up. Open the application. To verify that you have successfully updated the firmware, click on PHY --> Firmware Info. It should now show the new firmware information.